Description: Using 32-bit 100M Cortex-M3 LPC 1768 master chip, performance greatly improved. Support a high degree of modular open source firmware to facilitate the secondary development, eliminating the need to grasp the core code to worry about. Support network function, through the network cable can be directly connected to the network, the use of the browser can achieve remote control. Using 8825 as a motor driver to support 32 subdivision, performance far more than 4988, using SOP package, better heat dissipation The stepper motor current is set directly without worrying about damaging the drive or potentiometer when adjusting the current. The circuit board uses high-quality 4-layer board, and specially made heat optimization. Using a dedicated power chip to support 12V-24V power input. Can be connected to 12864LCD. Touch screen MKS TFT32. Specification: Material: four-layer PCB board Size: 146.5 * 95 * 5mm Scope of application: 3D printer Package Includes: 1X MKS SBASE V1.3 motherboard 1X TFT32 display 1X data cable 1X display cable Note: 1, please confirm again before and after power is connected, if it is due to the user connected to the power and burn out, we do not guarantee such problems! 2, please do not plug the motor in the case of power, easily lead to burn the drive; nor in the process of running the motor to adjust the current. The correct approach is to first disconnect the power, unplug the motor, and then re-power, adjust the potentiometer, measuring the voltage on the potentiometer, until the measured voltage is the same as expected. 3. At present, MKS SBASE can only use TFT series and LCD12864 display, can not use 2004, OLED display
