Description:
DC 24V 10A Digital Remote Control Motor Switch Controller For Linear Actuator
Specification:
Controller:
1, working voltage: DC12V/24V
2, output mode: passive output
3, contact capacity: 10A
4, load power: resistive 12V80W, 24V150W
5, working temperature: -10 ~ 70 degrees
6, receiving sensitivity: -107dBm
7, working frequency: 315MHz
8, product size: 80 * 62 * 28 (MVI)
Remote Control:
1, working voltage: 12V 23A battery power supply
2. Working frequency: 315/433MHZ
3, working current: 25MA
4, oscillating resistance: the same value as 4.7M of 2262 can be determined
5, encoding: fixed code / learning code
6, modulation mode: ASK (amplitude modulation)
7. Emission distance: 100-500M (This is the theoretical distance of no interference, and the actual distance is determined according to the interference size and receiving sensitivity of the environment, generally about 10%-30% of the nominal value)
8, product size (MM): 92 * 40 * 15
Features:
* Wide range of use, can be applied to motor motor reversing, DC lamps, access control, industrial control and security industry and other fields.
* Features with high confidentiality, stable performance and low power consumption
* No need to use the traditional jumper or DIP switch code, just the remote control with the receiver controller code can be used to achieve matching.
Application: Used in the field of motor motor reversing, DC lamp, access control, industrial control and security industry.
How to use? (Instructions)
Output: There are four output methods, signal interlock, signal non-lock, signal self-locking, signal lock and self-locking coexist.
(A normally open B public C normally closed)
1.Signal interlock: 12 connection, 34 not connected
Press the A key, the A relay is disconnected, and the relay corresponding to the B key is sucked and held, and the C key and the D key are operated as follows.
2.The signal is not locked: 12 and 34 are not connected
Press the remote control A key, and the A key corresponding to the relay pull, release the relay after the break, press the B key,
and B key corresponding to the relay pull, release and disconnect .C key and D key this Cycle work.
3. The signal from the lock: 12 connected, 34 connected
Press the remote control A key, and the A key corresponding to the relay to pull and hold, and then press the A key, A relay off.
Press the remote control B key, B key corresponding to the relay suction and hold, then press the B key, B relay disconnect, C key and D key to work as this cycle.
4. The signal from the lock and non-coexistence: 12 not connected, 34 connected
And the remote control corresponding to the four relays, two self-locking, two non-lock
Study method:
1.Press the receiver on the learning button light and then let go light to go into the learning state, click on the remote control of any key to learn,
the receiver receives the signal after the light flashes continuously after the study is successful.
2.Clear code: long press the code button for about 8 seconds to the code lights off the clear code is successful, clear the original learning
by the remote control will not be able to use, you must re-code before the remote control.
Package included:
1 x Controller
1 x Remote control
Warning:
Do not connect the wiring when wiring, so as to avoid short circuit damage to the motherboard,
the control of communication for safety should also be off after the good line to confirm the correct and then use power.
Note:
1. Please allow a bit error due to manual measurement. please make sure you do not mind before you bid.
2. The color may have different as the difference display, pls understand.
More Details:
