Description: 100W boost step up non-isolated module. 3V-35V adjustable output with voltmeter. Wiring: V-IN as an input, V-OUT is the output. LED indicator lights when converter works. Adjust output voltage and current with potentiometer. Specification: Material: PCB Borad Size: Approx. 60x50x20mm / 2.36x1.97x0.79inch Module: 100W Step-up Module Module Properties: non-isolated step-up module (BOOST) Input voltage: 3V-35V Input current: 10A (MAX) (Please enhance heat dissipation if more than 6A) Output voltage: 3-35V Adjustable Output current: 6A (MAX) (Please enhance heat dissipation if more than 5A) Operating temperature: -40 °C ~ +85 °C Operating frequency: 280 KHz The conversion efficiency: 96% (Max) Overcurrent protection: Yes (Automatically reduce if input/output voltage is higher than 12A) Short circuit protection: Yes (15A input fuse) Reverse polarity protection: No (Please install diode at the input port) Current voltage IST minimum resolution: 0.05V Installation: 4pcs 3mm screws Connection: Welding Package Includes: 1 Piece Step-up Boost Module Note: 1. Input circuit: 6-32V. Short input circuit: 3-10V. 2. Through the board jumper can choose whether is provided by the input or output the voltmeter supply (IN table is the input, OUT table is the output) lower voltage can reduce the voltage meter loss. 3. The jumper can be shorted with a jumper cap, remove the jumper cap, the voltmeter does not work. 4. The USB output for 3V or 5V, you can directly charge the phone, it should be noted that when using the USB output, please make sure is the output voltage consistent with your digital product voltage or not. Otherwise it will burn your digital products. 5. Each press to switch the display, long press 5 seconds off display. And then pess and hold for 5 seconds. 6. Through the back of the PCB fine-tuning potentiometer correction display, the module uses the high efficiency boost chip and the high current low resistance MOS tube, iron silicon aluminum high current inductance. 7. Stable performance. Thick aluminum radiator directly with the power tube close, cooling effect far more than the power tube surface, long time to work more stable. 8. Onboard USB interface, and has been used to identify the resistance, you only need to connect a lithium battery can form a large current mobile power
