ITEM NAME:110V-220V Pir Infrared Human Induction Lamp Switch Light Control Ceiling LigV8I9 110V-220V Pir Infrared Human Induction Lamp Switch Light Control Ceiling LigV8I9 Adaptive to filament, electricity saving lamp This lamp is internal equipped with auto body sensor.If poeple come.the lam will power on;if people leave,the lamp will power off Inner body auto sensor adopts infrared heat releasing device,and it can accurately capture moving low frequency signal and automatically power on Delay:20s (people are moving within the sensing range, the switch will auto delay and keep connecting;if people stay still,switch will stop responsing) Inner side of the lap is set up with auto ambient brightness detecting circuit.Only when ambient brightness is lower than setting value,the sensor will receive sense and let the lamp power off.And it is energy saving Output:Switching Transducer Theory:Optical Sensor Type:Biosensor Usage:Temperature Sensor Sensing Mode:PIR sensing + light control Rated Voltage:220V 50HZ Output Way:Controllable Silicon Load Power: filament lamp less than equal 100W electricity saving lamp less than equal 30W LED less than equal 15W Sensing Distance:3-6m(high temperature will influence switch sensibility) Sensing Angle:110 degree Sensitivity to light:darkeness Notice: When installing,please disconnect the power to guarantee safety Don't apply it to overpower current or voltage Don't install it accessible to water Detection distance will change according to ambient temperature's difference.In summer,detection distance is short(it is obvious when close to human body's temperature);in winter, detection distance will be far Don't install it in lower than -20 Celsius or higher than 60 Celsius Don't expose it to sun Don't install it in which there are moving objects The first time power on ,there will one minute initiation;during this period,the device will shine,it is normal phenomenon In coast zone,thermal flow will trigger the sensor because of ocean curr.Inner side of the lap is set up with auto ambient brightness detecting circuit.Only when ambient brightness is lower than setting value,the sensor will receive sense and let the lamp power off.And it is energy saving.
