ITEM NAME:12V Motorcycle Adjustable Temperature Electric Heated Grip Handle Cover Set T4E2 Features: [Product name]: 12V boat type adjustable high and low temperature electric heating handle [Product material]: PET metal heating film [Product size]: Length: 9.5CM; Width: 8cm [Input voltage]: 12V [Product power]: 10W (power on one side) 20W on both sides [Handle temperature]: low temperature: 30℃; high temperature 50℃-60℃ [Switch type]: three-stage adjustable switch [Product accessories]: a pair of left and right handles, a pair of heat shrinkable tubing; a waterproof insulating tape; a manual [Applicable models]: 12V all motorcycle models [Product advantages]: [1] Adopt simple modification method, that is, non-destructive appearance, convenient operation, and very simple installation [2] Using PET metal heating film, the heating speed is very fast, and it can heat up in a few seconds, safe and fast 3Adopting three-stage adjustable switch, you can adjust the high and low temperature at will according to your needs, and the design is very user-friendly [4] Switch design, can be directly installed on the rear-view mirror base, no need to punch, no need to damage, very simple [5] DC 12V input, suitable for all motorcycles, with a very wide range of applications [Installation method]: [1]: Put the electric heater on the handlebar and adjust it to a suitable position [2]: Use tape to evenly fix (wrap) the electric heating plate to the handlebar, especially the wiring of the electric heating plate should be tightly wound [3]: Put on the sleeve, adjust the position, use a heat gun (you can also use a lighter or a hair dryer) to blow the two creases of the outer sleeve longitudinally symmetrically until the shrinkage is uniform, and then blow other parts evenly until the outer sleeve Each part of the tube shrinks evenly and flat [4]: The switch is installed under the mirror rod of the rearview mirror [5]: Connect the power cord, the red wire and the black wire are both posit.[5]: Connect the power cord, the red wire and the black wire are both positive and negative, but they must be connected to the lower pole output line of the electric door lock (where the key is inserted).
