ITEM NAME:16 Channel 12 Bit PWM / Servo Driver Module I2C Interface For Arduino R6T3 16 Channel 12 Bit PWM / Servo Driver Module I2C Interface For Arduino R6T3 Or maybe you want to drive a lot of LEDs with precise PWM output. Then you notice that your microcontroller has a limited number of PWM outputs! What now you could give up or you could only get this handy and PWM servo driver eruption. When we saw this chip, we quickly realized what an excellent addition to this would be. With only two pins, control 16 free-running PWM outputs! You can even chain up 62 breakthroughs to control up to 992 PWM outputs (which we would really like to see since it would be glorious) It's an i2c controlled PWM driver with a built-in clock. 6 address selection pins so you can wire up to 62 of them on an I2C bus, a total of 992 outputs - that 's a lots of servos or LEDs 12C Input and control 16-channel PWM output Number of channels: 16 channel, Resolution ratio: 12 Bit Size about. 62.23 x 25.4 mm, mounting hole: Approx. 55.88 x 19.05 mm Pitch Series: Approx. 3mm supply file arduino (included arduino routine) Independent power supply to the rowing machine, with V + input, is the maximum 6V Single output of the logic signal and logical power: 3-5V. Frequency: 40-1000Hz Adjustable frequency PWM up to about 1.6 KHz 12 bit resolution for each output - for servos, means that about 4us resolution at 60 Hz update rate Configurable push-pull or open-drain output Output Enable pin to quickly disable all output We wrapped this lovely chip into a breakout board with some nice extras Terminal block for current input (or you can use the 0.1 / "breakouts on the side) Reverse polarity protection at the terminal block input Green power-good LED 3 pin connectors in groups of 4 so you can plug into 16 servos immediately (servo connectors are slightly wider than 0.1 / "so you can only stack 4 side by side at 0.1 /" header / "Chain location /" design A place to place a large capacitor on the V + line (if
