Features:
Wired:
Make sure the battery is not in the Microphone. And plug the cord to the microphone and your audio amplifier
Switch microphone to MIC position, and start to sing
Wireless:
Install batteries into both microphone and receiver. Switch on them, the connection will be built easily. With LED indicator
Switch microphone to ON position, and start to sing
Switch microphone to MIC position when you need a short break. It won't collect other voices to the microphone
If it does not work normal. Use a screw to press the RESET hole on the receiver
If you don't use it for long time. Please take batteries(not included)out to protect the microphone's components
Frequency range: FM
Frequency response: 100Hz-1000hz
S/N ration: ≥60dB
Directivity: uni-directional
Operating voltage: DC 1.5V
Service areas: 8~20 Meters
Reception sensitivity: 30dB/uV
Wired sensitivity: -50dB±3dB(0dB=1V/Pa)
Impedance: 600Ω
Note:
A receiver can only be used with one microphone, not with multiple microphones.
You can not use 2 or more Microphones with the same color indicator at the same time!
If two wireless microphones are used at the same time,you must use them with one red and one green indicator, and use them with both receivers turned on.
Package Included:
1 x Microphone
1 x Receiver
1 x Wireless antenna
1 x Microphone Cord
1 x User manual
OPERATION:
Insert a battery into the wireless receiver with the correct polarity, set the switch of receiver to"ON"position, now, the indicative light is indicating good condition
Plug the receiver into the input socket for microphone of amplifier or VCD
Screw off the body of microphone ,insert a battery with the correct polarity ,then screw up the body.Set the switch of microphone. Now ,the indicative light is indicating good condition.This indicative light is indicating good condition ,this shows it is ready for operation
When you need temporarily stop during singing and you don’t want the microphone to pick up any other sound,you may set the switch to the middle (MIC)position .Now ,the lamp is still on but your microphone doesn’t transmit any sound
Use it as wired microphone :Take out the battery from the microphone ,connect the wire with the microphone and set the switch to MIC position
Attentions:
If acoustic quality and volume are abnormal or receiving is shorted,the battery in wireless microphone and receiver should be replaced.If there is still not in normal operation,you can carefully trim the frequency of receiver with a screw driver to become normal operation.
If you don’t use your microphone for a long period,the battery should be taken out to avoid its deterioration and the damage of components
If two wireless microphone microphones are used at the same time,you must use them with one red and one green lamp,No using them with the lamp of the same color.
