ITEM NAME:433Mhz Wireless RF 4Channel Output Receiver Module and Transmitter EV1527 LJ Specification: Transmitting power: 11dbm Emission current: 10MA Rate of fire: maximum 10KB / S Operating Voltage: DC 3V-24V Encoding : EV1527 1527 Learning code Each module has a unique ID address code. All modules K1-K4 four key code is the same. Working Voltage : DC3.3~5V Quiescent Current : ≤5mA Output current : 10 mA Working Frequency: 433MHz Receive Sensitivity: -108dB Working Temperature : -25~75 Working mode: Momentary Mode , self-locking (Toggle-Mode of the 4 Channels) , interlocking The output: 4 channel CMOS level signal Corresponding to the remote control ABCD 4 buttons. [How to match the transmitter and receiver] 1. Delete existing data: Press learning button(on the receiver) 8 times. Response: LED flashes 7 times. 2. Learning remote code: press learning button(on the receiver) once, twice or three times (see below). LED turns on: learning mode is active. Press any button of the remote control. LED indicator flashes three times: learning successfully completed. 3. Test: after the above operation , the receiver board can be controlled by the remote control. More transmitters with different IDs can be learned and stored additionally, starting with step 2. A mixture of different modes is possible. Button usage (sets mode and starts pairing process): Press once: Inching mode (Momentary Mode) Press twice: self-Lock Mode (Toggle-Mode of the 4 Channels) Press three times: interlocked mode (selected channel active and be cleared, if another channel becomes active) Package Included: 1 * Receiver Module 1 * Transmitter Module〠2 * Black rubber line Note: 1.Under the influence of light and the display, the color difference may decrease slightly. 2.Due to manual measurement, please allow size differences about 1-3cm. Thank you for your understanding.Encoding : EV1527 1527 Learning code. Working Frequency: 433MHz. [How to match the transmitter and receiver]. 1 Transmitter Moduleã€. Output current : 10 mA. Button usage (sets mode and starts pairing process).
