ITEM NAME:50pcs/set Level Wedges Tile Spacers with Wrench for Flooring Tile Equalizer Product Description Description: 50pcs/set Level Wedges Tile Spacers with Wrench for Flooring Wall Tile Leveling System T-type Tile Leveler Equalizer Feature: 1. Wear resistant, recyclable. 2. It is easy to operate DIY. 3. Keep tile balance in the same horizontal position. 4. Improve the installation speed of ceramic tile. 5. Reduce fatigue / stress of installation personnel. 6. Almost no crack free, flat surface. 7. Reduces the need for grinding and polishing. 8. Prevent tiles from moving during curing. 9. The steel needle can be replaced and recycled. Specification: Material: high quality PP + stainless steel Scope of application: bricklayer Applicable brick gap: 1.5-6mm/0.059-0.23'' Applicable tile thickness: 7-17mm/0.27-0.66'' Tips for use: 1. Lay the first tile, leaving more than 2 mm (for use with cross gaskets). Close to the tiles. 2. Insert t-pins along the gap between the tiles. 3. Then rotate 180 degrees and the t-pins are stuck at the bottom of the two tiles. 4. Adjust the cover with a hand / special wrench until both tiles are on the same level. 5. About 5-6 hours after leveling, before the cement / adhesive is completely dried, rotate the cover in reverse direction, take out the 180 Â ° T-shaped needle until the word is filled, and take out. Avoid not removing the t-tile leveling system: 1. Tile gasket is 2mm or above (cross gasket is recommended). 2. When leveling, the cement or tile adhesive around the t-straightener must be cleaned. 3. About 5-6 hours after leveling, remove t-straightener before tile adhesive or cement is completely dried. Note: 1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you! 2. Please allow 1-2cm measuring deviation due to manual measurement. Included: 50 X Tile Leveler Equalizer 1 X Wrench.Included: 50 X Tile Leveler Equalizer. Prevent tiles from moving during curing. Improve the installation speed of ceramic tile. Lay the first tile, leaving more than 2 mm (for use with cross gaskets).
