ITEM NAME:A4988 Driver CNC Shield Expansion Board For Arduino V3 Part Engraver Integr F6Y1 A4988 Driver CNC Shield Expansion Board For Arduino V3 Part Engraver Integr F6Y1 Uses removable A4988 or DRV8825 compatible stepper drivers. The extension board can be used for carving machine, 3D printer driver expansion board. GRBL 0.8 compatible. (Open source firmware that runs on an for arduino UNO that turns G-code commands into stepper signals) PWM Spindle and direction pins,4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13) Compact design. Stepper Motors can be connected with 4 pin molex connectors or soldered in place. It is a total of four slots, can drive four A4988 stepper motor. Each road stepper motors only need two IO ports. In other words, six IO ports can be well managed three stepper motors. Very convenient to use. Parameters : dir direction control , dirPin corresponding stepper motor DIR pin , stepperPin corresponding stepper motor " step " pin , Step number of step of no return value. void step (boolean dir, byte dirPin, byte stepperPin, int steps); digitalWrite (dirPin, dir); delay (50); for (int i = 0; i Less Than steps; i + +); digitalWrite (stepperPin, HIGH); delayMicroseconds (800); digitalWrite (stepperPin, LOW); delayMicroseconds (800); UNO for Arduino module IO port correspondence introduction. UNO for Arduino---------------------- expansion board 8 ------------------------ EN ( stepper motor driver enable , active low ) 7 ----------------------- Z.DIR (Z -axis direction control ) 6 ----------------------- Y.DIR (Y -axis direction control ) 5 ----------------------- X.DIR (X -axis direction control ) 4 ---------------------- Z.STEP (Z -axis stepper control ) 3 ---------------------- Y.STEP (Y -axis stepper control ) 2 ---------------------- X.STEP (X -axis stepper control ) / / The following is a simple stepper motor control procedures, # define EN 8 / / stepper motor enable , active lo.Uses removable A4988 or DRV8825 compatible stepper drivers. The extension board can be used for carving machine, 3D printer driver expansion board. GRBL 0.8 compatible. (Open source firmware that runs on an for arduino UNO that turns G-code commands into stepper signals).
