ITEM NAME:Battery Storage Component Spot Welding Machine Welder PCB 12V Circuit Board DIY Description: Suggested Battery: 20-45ah battery with good performance and small internal resistance; 3.5-5.5ah 45C 3S aeromodel battery pack; 30-35ah capacity battery pack. Voltage: This circuit with a 12V battery will become an energy storage spot welding machine for welding nickel pieces.&;nbsp; Design: The MOS upper and lower bold and tin design makes the internal resistance smaller and the current stronger. Thickness: According to different configurations, the thickness can be about 0.1mm-0.15mm. More Stable: Using 25V low internal resistance Sanyo high frequency capacitors to make the power supply more stable. Tip:&;nbsp; If the battery is pretty good and the internal resistance is very low, and then there may be large current overload. If you are not sure about your battery, it's better to extend the wire by around 1 meter with 2.5Â ² or 4Â ² wire, then it will reduce the risk of power tube burnt. Specification: Material: PCB Color: as shown System voltage: 12V-14.6V Working current: 90-150A&;nbsp; Package:&;nbsp; 1 pc x circuit board 4 pcs x copper nose 4 pcs x screw 1 pc x buzzer 1 pc x 1 meter nickel sheet 1 pc x capacitance 2 pcs x soldering pen 2 pcs x input wire 2 pcs x heat shrink tube Note: 1. Due to the light and screen difference, the item's color may be slightly different from the pictures. 2. Please allow 1-2 cm differences due to manual measurement..1 pc x capacitance. Material: PCB. 2 pcs x soldering pen. 4 pcs x copper nose. 1 pc x circuit board. If the battery is pretty good and the internal resistance is very low, and then there may be large current overload.
