ITEM NAME:Cnc Z-Axis Setting Touch Engraving Tools Mach3 Router Auto-Check Instrument Descriptio n Feature: 100% brand new and high quality. CNC Router Mill Tool Setting Touch Plate Cnc Z Axis Router Mill Touch Plate Mach3 Tool Setting Probe New Milling Hot Kit These touch plates make setting your tool height and zeroing your z-axis a breeze. These are fully functional in Mach 3 and many other CNC controller software. Specification: Material: wire+metal Color: as pic shows Size: approx. 1.38*0.79inch/3.5*2cm (D*H) Effective surface of the knife: 25mm (0.98inch)diameter Line length: approx. 49.21inch/125cm (Including alligator clips) Two ways to connect this item: if your interface board has the limit switch port or other probe port, you can connect it to that port if your interface board does not have that port, your driver board has that port, you can connect it to the driver board's limit switch port then in the Mach 3, you need to setup the probe(Mach3 --- Config---Ports and Pins---Input signals Probe enabled , the pin number type the one you use) and the Auto-Tool-Zero. in the attachment, it is the code, you can edit it as your requirements Usage: The wire connect on the control panel interface. The clip and the control board GND (negative) is connected. The tool can be clamped portion of the operation when the knife with a clip. When the tool contacts the knife  that the process is complete. Package included: 1x CNC router engraving machine Tool Note: 1.Due to the manual measurement and different measurement methods, please allow 2-3cm deviation. 2.Please be reminded that due to lighting effects and monitor's brightness/contrast settings etc, the color tone of the website's photo and the actual item could be slightly different. We offer you what you need! Cnc Z-Axis Setting Touch Engraving Tools Mach3 Router Auto-Check Instrument.Then in the Mach 3, you need to setup the probe(Mach3 --- Config---Ports and Pins---Input signals Probe enabled, the pin number type the one you use) and the Auto-Tool-Zero. z-axis a breeze. if your interface board has the limit switch port or other probe port, you can connect it to that port.
