ITEM NAME:CS-095D1 7/8 Motorcycle Handlebar Electric Heated Grips for Motorbike ATV A#S Product Description Description: CS-095D1 22mm 7/8 inch Motorcycle Handlebar Electric Heated Silicone Grips Motorbike ATV Handlebar Warmer Feature: 1. 12V voltage, suitable for 22mm diameter motorcycle handlebars 2. The product is equipped with high and low gear switches, and the handle temperature can be adjusted at will (50℃-70℃ adjustable) 3. Double throttle cable buckle, wider installation range 4. The design can be sealed and can be pierced, which does not affect the installation of the handle outside the handle, and then the lights and other decorative accessories are more beautiful and convenient Specification: Product model: CS-095D1 Product net weight: 236g Product gross weight: 260g Product color: black Grip size: 143*36mm/5.63*1.42" (left) 127*36mm/5.00*1.42" (right) Grip inner diameter: 22mm (7/8 inch) Input voltage: 12V Product power: 15W-35W adjustable Grip temperature: 50℃-70℃ adjustable Switch type: multi-temperature adjustable switch Applicable model: for 12V motorcycles with handlebar diameter of 22mm (7/8 inch) Installation note: 1. Remove the original handlebar grip. 2. Use your left hand to moisten the inner hole with soapy water. The twist angle should not be too large during installation. 3. When installing the balance iron on the left grip, adjust the position of the balance iron to be slightly separated from the grip, and do not squeeze the grip when tightening the screw. 4. If you use the left grip to slide on a steel pipe, remove the balance iron and fix it with a few drops of 502 glue from the end of the grip. 5. The power cord, the red wire is connected to the positive pole, and the black wire is connected to the negative pole. The temperature cannot be adjusted when reversed. 6. When installing the left-hand grip, the power cord should be left enough for rotation. Precaution: 1. When installing the left grip, do not twist the grip too much. Excessive.Remove the original handlebar grip. Do not squeeze the grip when tightening the screws. The balance iron is slightly separated from the grip. When installing the balance iron on the left grip, adjust the position of the balance iron to be slightly separated from the grip, and do not squeeze the grip when tightening the screw.
