1. Material: (heating sheet) composite fiber heating wire + black non-woven fabric, (L bracket) stainless steel
2. Cord length: 120cm
3. Input voltage: DC12V
4. Power: about 20-30W
5. Handle temperature: 40 degrees, 50 degrees, 60 degrees
6. Installation method: 3M glue fixed, L bracket lens holder fixed
7. Net weight: 83g
8. Accessories: heat shrinkable tube sleeve * 2, Rearview mirror bracket * 1 Cable tie * 3, Insulating tape * 1, 3M adhesive * 1
9. How to use the switch: Press and hold for 3 seconds to turn on the device. The red breathing light will light up. When it reaches a certain temperature, it will automatically turn blue. Press it once to change the temperature of the blue light to medium temperature. Lowest, press three times for the red third gear high temperature, press and hold for 3 seconds to turn off, and automatically turn off after 2 hours of standby, no longer need to worry about the virtual power consumption
10. Waterproof and flame retardant, more uniform and stable heating, more comfortable feel
11. Built-in intelligent temperature control chip, three-stage temperature adjustment, intelligent temperature control is more secure
12. Fast heating in 10 seconds, large heating area
13. The product has added a standby mode. After switching to standby mode, the electric heating handle will be automatically thermostated to about 50 degrees, and it will automatically shut down after two hours. You no longer have to worry about exhausting the motorcycle battery because you forget to turn off the switch.
Instructions:
1. Power on: the red light, blue light, and green light each flash once and then go out.
2. Standby: red light breathing blinking state, the temperature will automatically turn into blue light mid-range automatically after 2 hours of automatic shutdown
4. Press and hold the key for 3 seconds: enter standby mode or shut down
5. Click on the key: switch gear
Wiring method:
1. Connected to the electric door lock (behind the key) of the motorcycle, the red wire is connected to the positive output wire of the electric door lock, and the black wire is connected to any negative pole or ground on the car. [This method is suitable for those who do not want to use the standby state but are easy to forget. Cheers who turn off the switch]
2. Connected to the positive and negative positions of the battery, red is connected to the positive electrode of the battery [+], and black is connected to the negative electrode of the battery [-]. Because this electric heater handle has added the function of automatic shutdown on standby, even if the battery has forgotten to turn off the switch, just turn on In standby mode, you do not have to worry about running out of batteries (it is recommended to turn on the standby mode in advance)
