DC 24V Infinite Loop Cycle Timer Delay Time Relay ON OFF Module 1S-15Min T9 H8A2

ITEM NAME:DC 24V Infinite Loop Cycle Timer Delay Time Relay ON OFF Module 1S-15Min T9 H8A2 DC 24V Infinite Loop Cycle Timer Delay Time Relay ON OFF Module 1S-15Min T9 H8A2 This module uses MCU as the main chip, greater precision of time. MCU surveillance circuit and special reset chip. Stable and reliable work performance. Work model: one time mode and cycle mode. The delay time error of all types of temperature and humidity is less than 2%. Budget: Once mode (Jumper OP3) The ignition module, after being fired, the relay is on, the delay T1, and the relay is disconnected. In the delay process, firing again, will immediately interrupt the delay. Cycle mode (bridge OP4) The ignition module, after the relay is activated, the delay T1, and the relay is disconnected, the delay T2, the relay is switched on again. That cycle. T1 and T2 are adjusted by means of two adjustable resistors, respectively. In the delay process, activated again, the delay will be immediately interrupted. OP1 Bridge: 1 to 100 seconds, 0.1 seconds of regulation precision Jumper OP2: 1 second to 15 minutes, 1 second of regulation precision Typical application reference Tune the operation equipment, just like each trigger by pressing the key, then automatically turn off after 5 minutes. Machine repeat the test circuits, as a test cycle: turn on for 1 minute, then off for 1 minute. Fish tank pump intermittent oxygen pump. Other timer control equipment. DC: 24V Module size: 10 * 3 * 0.5cm / 3.94 * 1.18 * 0.20 inch material; metal color: blue Package includes: 1 x Infinite cycle timer relay module Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/-1-3cm..That cycle. The ignition module, after being fired, the relay is on, the delay T1, and the relay is disconnected. MCU surveillance circuit and special reset chip. Machine repeat the test circuits, as a test cycle: turn on for 1 minute, then off for 1 minute.