ITEM NAME:K-300 UV Liquid Glue Cure Adhesive Transparent Crystal Bonding Repair Glass U5K8 description: 100% high quality Type: UV glue Capacity: 50 ml Appearance: colorless or light yellow transparent liquid Use the following steps: Depending on the surface treatment of the material, the surface is dry and clean without a weak boundary layer. The bonding material on the interface adhesive needs to be applied continuously, taking care not to disperse. Gently place the glue under the short radiation of the UV curing lamp until it is gently pushed by hand. Use a knife to remove excess glue and scrape off the glue, or wipe it gently with a soft cloth and a paper towel. Wipe off excess glue, or rub with acetone or alcohol; Full cure time with high radiation until fully cured, pay attention to the temperature is not too high; Use a soft cloth or paper towel to rub the acetone, alcohol and cleaning material, then gently wipe the bonded material. Instructions for use: The surface of the adhesive is clean, dry and free of grease. It can be wiped with acetone or a hair dryer. Place the UV lamp in the curing position, which depends on the light energy absorbed by the glue from the glue. Related to the light source is the light transmissive material and other factors. This operation should not be too squeezing to become sticky, and the adherend should not be repeatedly separated. Do not use the remaining glue to return to the original packaging to avoid contamination. K-300 is a modified UV or visible light curing acrylic adhesive with low odor, high transparency, high adhesive strength, low viscosity and easy degassing. It is usually used for large-area glass crystal bonding, for example: glass mosaic. , glass crafts, crystal crafts. Storage: This product is sensitive to light and heat. You need to store it in a cool and dry place, away from light below 28 degrees Celsius, valid for one year. Package Included: 1 x UV glue A.The bonding material on the interface adhesive needs to be applied continuously, taking care not to disperse. K-300 is a modified UV or visible light curing acrylic adhesive with low odor, high transparency, high adhesive strength, low viscosity and easy degassing.
