Product Introduction:
K-0271 is a single component, medium viscosity, high strength anaerobic thread locking sealant. This product is used between close fitting metal surfaces and cured and air separation. Available Hand Tools Demolition
Applications:
Avoid loosening and leakage of threaded fasteners. M36 thread fasteners for permanent locking and sealing, to prevent thread corrosion.
Typical uses:
Studs screwed into the end locking (such as cylinder head studs)
Specification:
Base material chemical composition: methacrylate
Appearance: red thick liquid
Viscosity (mPa) s) : 300 ~ 800
Specific gravity: 1.05
Flash point: > 108
The biggest fill gaps (mm) : 0.13
At room temperature curing time (min) : 20 or less
After curing performance:
All solid at room temperature time (hr) : 24
Failure moment (N, m) : 20
Average removal torque (N, m) : 20
Working temperature: 54-149
Instruction manual:
1. The coated surface should be clean, dry and free of grease.
2. Insert the bolt painted in sufficient quantity to fill all engaged threads, a thin layer of this product work results in a 0.05 mm or less optimal.
3. For large thread sizes, larger gap will affect cure speed and strength of the product. This product will reduce the friction force (torque tension ratio) assembly generated. The need to screw fastening applications to the critical value, the need to determine in advance the good of this ratio.
Caution:
This product should not be used on plastics; in order to avoid contamination of the original glue, do not have poured the glue back to the original packaging.
Safety Precautions:
This product contains methyl acrylate, skin and eye irritation. If skin contact, immediately wash with water; if touching the eyes, immediately rinse with water and go to hospital for treatment.
Storage conditions:
Cool in the temperature range of 15 ~ 28 , dry place sealed, shelf life of up to 12 months.
Packaging Included:
1X Kafuter K-0271 Screw Glue
