Description:
Product model: BLDC3650
Shaft length: 9mm casing plane to shaft head
Working voltage: 12V or 24V
Lead length: 27cm
Auxiliary diameter: 3.175mm diameter shaft
Power: 24V 8300 rpm Maximum power about 30-40W
Drive mode: built-in sense of Hall drive
Product size: 35mm* 25mm*9mm
Firmware performance: brushless stator quadrupole magnetic brushless rotor 6 slot structure
Outer diameter size: 36mm length dimension
| Rated voltage (V) |
No-load current (mA) |
No-load speed (pm) |
Rated torque (g.cm) |
Rated speed (rpm) |
Rated current(A) |
Protection voltage (W) |
Drive protection current (A) |
| 12.0V |
≤230 |
4150 |
50 |
3400 |
≤0.8 |
30.0 |
3.0 |
| 24.0V |
≤300 |
8300 |
100 |
6800 |
≤1.6 |
30.0 |
3.0 |
Warning: power plus or minus pole fault, power supply and negative pole touch FG line, will damage the drive board, resulting in damege to the motor
BLDC3650 five line connection mode:
1- black line: power - (blue line is connected to the negative pole motor immediately brake)
2- red wire: power +
3- white line: CW/CCW communication line, the white line and black line connection to change the steering.
4- yellow line: FG signal line output Holzer signal, based on the oulse of a ring signal.
5- blue line: PWM pause width modulatiuon line can be connected to 0-5Vpulse width governor.
BLDC3650 speed regulation connection method:
(Note: speed regulation power supply and motor power supply is indepemdent.)
1- in the PWM speed control interface input amplitude is 5V, the frequency of the PWM signal 10K;
2- when the duty ratio of is less than 10% (2%), trhe motor is in a static state;
3- duty cycle adjustment by 10%~100%, corresponding to the motor speed form the lowest to the highest;
4- connection line is connected to trhe blue PWM governor middle tripod feet;
5- with the motor power supply common ground black motor line- this line must be shared with the motor negative;
6- PWM governor in addiction to one foot must be connected to a separate power supply 0-5V + pole.
How to use the motor:
1. Use tolerance: Pay attention to the use range of voltage and current, use the motor under the conditions specified in this standard, otherwise the life of the motor will decrease.
2. Handling the motor: Take it lightly and use the motor casing as much as possible.
3. Motor wiring: the red lead is connected to the positive pole, and the black lead is connected to the negative pole. If the reverse motor rotates in the opposite direction.
4. Overload: use as much as possible within the load range specified by our company.
If the motor is blocked or close to the blocked state, it will run for a long time, otherwise the motor will burn out.
5. Motor storage: Storage temperature: 0°C-40°C, storage humidity: 15%-90%RH Avoid placing in high temperature, high humidity and corrosive gas environment.
6. Motor operating temperature: 0°C-70°C
Notice:
1.Please allow a bit error due to manual measurement. please make sure you do not mind before you bid.
2.Due to the difference between different monitors, the picture may not reflect the actual color of the item.
More Details:
