ITEM NAME:Oil Pump Suction Pump Pump Oil Drain Device Vehicle Oil Suction Pump Transf N1R6 Oil Pump Suction Pump Pump Oil Drain Device Vehicle Oil Suction Pump Transf N1R6 Above all, let the engine run. When the oil temperature is around 50 degrees, use this oil pump to pump oil. Connect the pump to the power supply, allow it to run, and see if the inlet and outlet are normal. Open the filler cap, pull out the dipstick, push the tube into the bottom of the joint until the tube does not move; Then insert the inlet pipe from the dipstick into the end (place the pipe in the bottom of the tank, the lower concave place to completely pump the oil); Since no oil or pumping is very slow or intermittent, it is usually caused by loose pipes and fittings. You have to reinstall the pipes and fittings.) After oil pumping, remove the hose and then run the pump for a while. The remaining oil within the pump is cleaned until the pump head becomes clean. If you have not used it for a long time, it may not have any suction, then just pour the water into the pump. And you run the pump for a few minutes. Application: Most is used in general industrial equipment, medical equipment, chemical equipment or shipbuilding It works by connecting the brackets to the 12V car battery This oil pump is a Perfect equipment for quick and clean oil changes Simple on / off switch, easy to use 100% brand new and high quality; Rated voltage: DC 12V; Rated power: 60W Rated voltage: DC 12V Rated power: 60W Maximum pressure: max 0.8 MPa Color: Black Material: PP Size: 160 * 50 * 50mm Pump diameter: approx. 48mm Length: approx. 14.5 cm Outlet pipe size (？ * L): approx. 11mm x 140cm Inlet pipe diameter: approx. 8 mm, 6 mm Length: about 100cm Cable length: approx. 30cm Package contents: 1 x oil pump 1 x 11 mm discharge pipe 1 x 8mm hose line 1 x 6mm hose line 1 x user manual
