ITEM NAME:Professional Sensor Gel Stick Dust Cleaning Pen Jelly Camera Filter Lens Cl T5G3 Professional Sensor Gel Stick Dust Cleaning Pen Jelly Camera Filter Lens Cl T5G3 The gel sensor stick is a professional cleaning solution for your camera CCD, CMOS, filter lens other delicate equipment. It is generally used by a few manufacturers in their service centers or for the individual use. It is a stick featuring a piece of sticky gel on one end that you just simply press and remove over and over to pull all of the dust and oil off of your sensor and surface. When the gel gets dirty enough, you pull out a piece of sticky paper, remove the dirt and keep going. Material: Plastic + Silicone Color: White + Blue Length: 15cm/5.91 inch(appr.) Brand New and high quality. Dry cleaning and leave behind no residue. Remove the dirt with the coming sticky paper or water. Comes with the box for additional convenience. Apply to your camera CCD, CMOS, filter lens, and more. Easy and safe to use, you just need to stick and pull repeatedly. Properly preserved, the gel stick can be reused about 200 times. Instructions for Use: 1. Make sure the camera is in the raised position before cleaning. 2. Do not open the fan before and after cleaning, as far as possible in the environment without flying dust. 3. Set the camera aperture f/22, take a few photos of the white paper, and remember the location of the stain. 4. It is better take a mask, because when clean CCD/CMOS your face will be very close to the camera, breathing will sometimes put some small dust blowing. 5. The jel pen should be cleaned on the paper, and the jel pen should not Press anything except CCD/CMOS. 6. After cleaning a stain, press the head of the attached paper, the pressure of the place should not be reused. 7. It is best to clean up the stain place, not the whole piece of CCD/CMOS. 8. When the gel gets dirty enough, you pull out a piece of sticky paper, remove the dirt and keep going. 9. Clean jel pen, pay.It is generally used by a few manufacturers in their service centers or for the individual use. It is a stick featuring a piece of sticky gel on one end that you just simply press and remove over and over to pull all of the dust and oil off of your sensor and surface.
