1. Various functions, not only can be used as a buoyancy bar, but also can be used as a heightening tripod and landing gear, effectively increasing 60mm
2. Non-destructive installation design, easy to install, can be disassembled and assembled by itself
3. Wear 1/4 adapter, can extend other parts, used with camera, fill light, etc.
4. Lightweight design will not bring a heavy burden to the drone
5. Material: ABS
6. Dimensions: 247x240mm
7. Note: The floating kit allows the drone to land or take off in calm water instead of in rough water, otherwise the drone may be lost
8. Packing list: buoyancy rod main board * 1, buoyancy rod top cover * 1, buoyancy rod * 2, tripod * 4, M3 * 6 * 12 screw * 2, 1/4 * 10 screw * 1, tripod adapter * 1, m5 screw * 1, gasket * 1, electrostatic bag * 1
Installation steps:
1. Place the main installation cover on top of the drone
2. As shown in the figure, fix the four sponge stick mounts on the main mount connection part
3. Turn the drone over, and then align the main mounting bracket with the bottom of the drone
4. Fix the main bracket and the top cover of the main bracket with two M3 screws on the drone
5. Insert the sponge stick into the ring of the main fixing frame, and adjust each stick to the proper balance position
6. After adjustment, place the drone on the water and check the balance. If unbalanced, adjust the position of the sponge stick and balance it back and forth
