TMC2130 V1.1 Stepstick Stepper Motor Driver Features:
1.Two-phase stepper motor single-phase current 1.2A (peak 2.5A) motor operating current can be adjusted
2.SPI only
3.Subdivided into 256
4.Noiseless operation combined with maximum efficiency and optimal motor torque
5.High-precision sensorless motor load detection
6.Reduce energy consumption by 75%
7.High load drive is not out of step
Specifications:
- Motor input voltage range: 4.75~46V
- Logic interface input voltage: 3 ~ 5V- Interface: Step/Dir or SPI
- Configuration: CFG Pins or SPI
- Native Microsteps*: up to 1/256
- MicroPlyer
- Microsteps: 1/256
- Logic Voltage VIO: 3-5V
- Motor Voltage VM: 5.5-46V
- Motor Phase Current: 1.2A RMS, 2.5A Peak
- VM always needed**: yes
- Internal V- Regulator**: enabled
- RDSon: >=0.5 Ohm
- StealthChop (quiet): yes
- SpreadCycle: yes
- CoolStep: yes
- StallGuard: yes
- DcStep: yes
Stepstick SmootherDescription:This smoother is mainly for the elimination of printed marks produced by 3D printers and the parallel arm structure, can effectively eliminate low-speed non-uniform waveform signal so as to achieve a relatively flat signal waveform.Features:
1. Plug and play, no wiring required
2. Effective to usePackage Included:1x TMC2130 V1.1 Stepstick Stepper Motor Driver
1x Stepstick Smoother1x Heat sink
1x Screwdriver
1x 4pin connection cable
V1.1 TMC2130 & V1.0 TMC2130 Comparsion:
How To Install TMC2130 Driver On the Mainboard:
